Operating Instructions - Bonitor MP201 User Manual

BONITOR Mini Projector MP201

Operating Instructions

Recharging MP201
Slide the power switch to OFF mode and recharge MP201 with the included
AC adaptor / charger. LED light flashes once per second during recharging.
Full recharge takes probably 4-5 hours. LED light will stop flashing once the
battery is fully recharged.
Functioning MP201
1. Connecting a device
MP201 auto-detect video signals from an external video device with correct
cable connection. (1) Connect the included RCA cable to MP201. (2) Connect
another RCA cable to your video device. (3) Connect two RCA cables with the
included RCA adaptor.
2. Turning to video output mode
Manual settings should be required for your video device. Turn your video
device to video output mode. If you have problems on turning it to video output
mode, please consult the documentation of your video device or the
manufacturer.
3. Powering on
Slide the power switch of MP201 to ON mode. The LED light will turn on and
project the detected signals. If no video signal is detected, MP201 will not
project anything and the LED light will flash twice per second.