Installation - DeLonghi Dehumidifier Quick Manual

Installation

Place the appliance in the room that you wish to dehumidify.
It is essential to leave a space of at least 50 cm. around the appliance in order to ensure adequate
ventilation.
The condensation can be discharged in one of two ways:
A) Discharge into the canister
The condensation generated by the
dehumidifier can be discharged directly into
the canister which is located inside the
appliance (fig. 1).
The canister is easy to extract when it needs
to be emptied. It has an ergonomic form and
is equipped with a handle which makes it
easy to carry and to empty.
B) Continuous External Discharge
If you need to have the appliance working for a long period of time but are unable to empty the
canister repeatedly, it is possible to use the continuous discharge.
It is extremely easy to set the canister up for continuous discharge.
1) Remove the rubber stopper from the spout.
2) Make a hole on the inside of the canister spout using a drill with a fine bit. Fig. 2.
3) Attach the rubber hose to the spout.
4) There is a special pre-marked hole on the panel door of the appliance to allow the hose to pass
through (fig. 3). Before passing the hose through this hole, it is necessary to remove the central disk
from the hole. Be careful to make sure the hose does not have to go "uphill", or the water will be
left inside the canister.
N.B. Keep hold of the rubber stopper: it can be used both for blocking the hose and for
plugging the spout if the canister is used for discharging in the future (see point A).
Canister Control System
This dehumidifier is equipped with a special intelligent device which checks that it is working
properly.
A warning lamp placed on the control panel comes on to warn the user when:
1. the canister is full
2. the canister is missing
3. the canister is badly positioned
4. you are using the continuous discharge and there is a blockage in the hose or the hose goes
"uphill" remove the blockage.
Once the cause has been removed, the warning lamp goes off and the appliance starts working
again.
Fig. 2
empty the canister
put the canister back into position
position it correctly
Fig. 1
Fig. 3
13