Download Print this page

DALLEE ELECTRONICS Speakers Manual page 9

In locomotive steam chuff sound for various track power
Hide thumbs Also See for Speakers:

Advertisement

Switch Synchronization:
1 - connect Common (C) of the switch to the White wire from the SYNC input.
2 - connect Normally Open (NO) of the switch to the Black wire from the SYNC input.
Switch closure should occur on peaks of quartering lobes. We recommend using optics since they
can switch much faster, don't bounce, and do not interfere with the mechanical operation of the axle.
Item #707, as shown,
is a subminiature micro switch for this purpose, in lieu of using
optics (0.32"L X 0.1" W X 0.26" H).
DO NOT use a leaf switch to the chassis (quartering lobe) this will damage the sound unit!
Focus Distance
1/8" - 3/16"
Optical Coupler (hi-lighted for ease of
viewing) mounted to frame 3/16" from
optical end to pattern. In this installation,
the end mounting ears had to be trimmed
to obtain clearance to the drive gear box.
When doing so care must be used to not
damage the optics.
Synchronization of Exhaust Chuff
For optical coupler (item #585) synchronization:
1 ...... connect Black and Green optical pickup wires together, this then connects to the Black wire
2 ...... connect Red optical pickup wire to the Red wire from the SYNC input.
3 ...... connect White optical pickup wire to the White wire from the SYNC input.
For extra 2 and 3 pin ultra-miniature connectors, see item's 757 and 758.
It is not necessary to use the black / white stripe pattern, anything that will
come in and out of focus to the optical reader will also work! So, engines with
cams installed or a piece of plastruct rectangular tubing cut and glued to the
axle may also work with proper alignment.
Optical pattern
Remember, some paints and other type markers will still reflect the infr-red
mounted on
light. So, just because it's black doesn't guarantee that it will work. The
drive axle
optical coupler comes with laser printed stripes, included on page 10.
apply a thin layer of
glue on each side to
prevent oil from
contaminating the
optical pattern.
9
from the SYNC input.
see page 11 for picture of installation.
They are listed under Accessory Items / Connectors.
WHITE
GREEN
BLACK
RED

Advertisement

loading

Related Products for DALLEE ELECTRONICS Speakers