Table of Contents
Advertisement
Trouble shooting
Question
When using the camera
The camera has no power.
Cannot power on my
camera even though
battery is installed.
Cannot take pictures and
movies when pressing the
SNAP button .
I did not delete the picture
and movie, but cannot find
the data in the SD/MMC
card.
Cannot set the strobe to the
"On" mode.
Answer
The battery may be out of power,
please charge the battery.
Make sure that the battery is installed
correctly.
Make sure that the battery is installed
correctly.
If it is idle over 3 minutes, the camera
will shut down automatically, please
press the Power wake up button
to restart.
Make sure that the power is on
The storage is full. Please free some
space of the SD/MMC card or flash
memory.
Check if the camera is under the status
of charging batteries.
Check if the SD/MMC card is set to
"protected".
If the "MEMORY ERROR" message
shows on the LCD display, please set
the Mode switch to
the card.
Check if your files are stored in the
camera's built-in memory. If there is a
icon at the right bottom section on the
LCD display, it means you are using the
camera with a SD/MMC card. Please
remove the card to find the data in the
flash memory. (For details, refer to the
"Removing the card" section on page 3)
Charging the flash strobe requires more power
"to"
battery.When the battery is under the
status of low power,the strobe can't work.
Please charge the battery.
~ 24 ~
mode format
Advertisement
Table of Contents
