Advertisement
InstrUctIons For Use
Fluid dispensing
1. Unscrew the cap from the fluid transfer
bottle, and fill to desired level with clean
fluid.
2. Reinstall the cap onto the bottle and hang
the assembly in a safe, secure location
within reach of the application.
3. Close the ball valve located on the fluid hose
assembly extending from the bottom of the
bottle.
4. Connect the fluid dispensing wand or other
accessory to the quick-change coupler on
the end of the fluid hose assembly. Ensure
the coupler sleeve snaps forward to lock the
connection.
5. Connect a Mityvac hand pressure pump w/
pressure gauge to the inlet hose extending
from the side of the fluid transfer bottle.
6. While observing the gauge, operate the
pump to build pressure in the fluid transfer
bottle to the desired level. Do not exceed
1.4 bar (20 psi) pressure.
7. Insert the fluid wand into the reservoir you
wish to fill or top-off, and open the ball valve
to allow the flow of fluid.
note: Continual operation of the pump is
not required to maintain fluid flow. Fluid will
continue to flow as long as there is pressure
in the reservoir and the shutoff valve is open.
Hand pump
(sold separately)
TYPICAL DISPENSING/
EVACUATION APPLICATION
Page Number - 6
8. Once the proper amount of fluid has been
dispensed, close the shutoff valve and
release the pressure in the system by acti-
vating the pressure relief lever on the hand
pump.
9. Depending on the type of fluid and future
intended use, you may store the remaining
fluid in the reservoir. Otherwise empty the
bottle assembly, clean it with denatured
alcohol or a common household cleaner,
and store it properly.
Fluid evacuation
1. Hang the fluid transfer bottle assembly in
a safe, secure location within reach of the
application.
2. Close the ball the valve located on the fluid
hose assembly extending from the bottom
of the fluid transfer bottle.
3. Connect the fluid dispensing wand or other
accessory to the quick-change coupler on
the end of the fluid hose assembly. Ensure
the coupler sleeve snaps forward to lock the
connection.
4. Connect a Mityvac hand vacuum pump to
the inlet hose extending from the side of the
fluid transfer bottle.
5. Operate the pump to build vacuum in the
bottle.
Fluid dispensing wand
Brake master cylinder
Form 824889
Advertisement
