HOW TO CLEAN YOUR FREEZER INSIDE
Remove the plug from the mains socket, and remove all
loose accessories before cleaning the freezer.
The best time to clean your freezer is after defrosting and
before the electricity supply is connected again.
Use a damp cloth to clean your freezer. Use hot water,
and a mild, non-aromatic cleaning agent.
After cleaning the freezer, clean the basket/baskets
before replacing them.
Never use strong cleaning agents, scouring powder
or strongly aromatic cleaning agents to clean your
freezer inside, since this will damage the inside and
leave a strong smell.
Green light not on
Green and red light on
Green light on, red light
Yellow light on
Yellow light not on
Too much frost
Lid does not close
Lot of moisture in the
Goods packed poorly
If you are still unable to solve the problem, summon the
assistance of authorised service staff.
Do not take any other steps. Incorrect procedure may
cause personal injury or lead to additional defects.
It is quite normal for the freezer to seem warm on the
outside occasionally, owing to the heat generated by the
freezing process. This heat also helps to prevent the
formation of moisture on the outside of the appliance
which could cause rust.
If the freezer has been switched off briefly, the
compressor may not start immediately when the current
is re-connected. This is quite normal.
IN THE CASE OF A POWER FAILURE OR
The hold-over period mentioned in the "Technical
Specification" section of this book refers to an estimated
time the freezer temperature will take to rise to an
unacceptable level for keeping frozen foods.
Providing the period of power failure or breakdown does
not exceed the hold-over period there will be no risk of
damage to the frozen food, providing you do not open the
lid during this period.
If the freezer is only half full or the lid is opened this will
reduce the hold-over time.
Wash the outer cabinet with warm soapy water. Do NOT
use abrasive products.
WHEN NOT IN USE
IF SOMETHING DOES NOT
IF YOUR FREEZER DOES NOT
Check the following before calling for service staff:
Plug not connected correctly
Defect in switch or fuse
Fresh food recently placed in freezer
Lid open too long
Thermostat set too warm
Lot of frost and ice formed
"Super" function active
Thermostat set too cold
Lid in contact with goods in freezer
Moisture from washing machine,
Lot of moisture from goods
After the breakdown period you are recommended to
check the condition of food to ensure it has not started to
thaw. Frozen food must NOT be re-frozen once it has
thawed out. The following guidelines should assist you.
Fruits & Vegetables: If soft should be cooked and used
Breads & Cakes:
HOW TO CHANGE THE BULB (10)
Before changing the bulb, isolate the appliance from the
Unscrew the bulb, and replace it with a new bulb (max.
15W). Then reconnect the electricity supply.
Disconnect the appliance from the electricity supply.
Remove all goods from the freezer.
Clean the freezer as described above.
Leave the lid slightly open.
Check plug and socket
Check fuse, call electrician
Wait until current returns
Wait a couple of hours
Wait a couple of hours
Set thermostat colder
Press "Super" button out
Set thermostat warmer
Re-arrange goods, check that lid closes
Move freezer to a room with less
moisture, or air regularly
Re-pack goods, see under "How to
Can be re-frozen without danger.
Should be refrigerated and used
refrigerated and used up.
Should be cooked and can then
be re-frozen as cooked dishes.
Should also be cooked and re-
frozen as a cooked dish.