Contents ………………...…………………………………….3 Safety Instructions …………………………………...………………….5 View of Front Panel ……...……………………………………………….6 View of Side Panel ……...……………………………………………….7 System Connection ……..………………………………………………..8 Power Supply Preparation ………..…………………………………………..…9 Troubleshooting ……………..………………………………………..10 Specifications...
Safety Instructions The lighting flash with arrowhead symbol, within a triangle, alerts the user to “dangerous voltage” which could cause electric shock. The exclamation point within a triangle is indicates to the user to read important operating and maintenance instructions in the manual. POWER SUPPLY: Connect the supplied adapter to the side of the DVD player in the slot marked “Power In”.
Page 4
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 11) Only use attachments/accessories specified by the manufacturer. 12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus.
View of Front Panel -/+ button Press to adjust the value of brightness and color. FUNCTION button Press to change the brightness and color level. Press and hold for 1-2 seconds to change the aspect ratio. POWER button Press to access to or exit from the standby mode. Power Indicator In normal playback status, it doesn’t indicate and it turns red in standby mode.
View of Side Panel Volume Control Used to adjust the volume of the headphone and speaker. Headphone Jack Used to connect headphones for private listening. When the headphones are connected to this jack, the speaker will be turned off automatically. Audio Input Jack Used for audio input.
System Connections Connect to Master DVD player Make sure that the master DVD player, slave LCD screen and any other electrical equipment are off before connection. Connect the car power adapter to the slave LCD screen and connect the slave LCD screen with the master DVD player using power supply cord to supply power to the master DVD player.
Power Supply Preparation Using the AC Adapter Connect AC adapter to the jack marked DC 9.5V IN on the right side of the slave LCD screen, as shown below. Plug the other end of the power cord into the wall AC outlet. NOTE: Turn player's power off before unplugging.
Page 9
Power Supply Preparation Using your Car Power Adapter Connect the Car Adapter Power Plug to the slave LCD screen’s power jack and plug the other end to the vehicle’s cigarette socket as the figure shows below. Attention Do not operate the unit or view video software while driving a vehicle. Place the unit in a proper position for viewing.
Troubleshooting SYMPTOM HOW TO CHECK - Make sure system connection is correct. There is no sound. - Make sure the speakers are turned on. - Make sure the audio source is correct. - Make sure LCD screen is on and in correct video mode. There is no picture.
Dimensions 9.1” x 6.1” x 1” (H*W*D) Weight 1 lb DESIGN AND SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE For service, support and warranty information, visit www.polaroid.com. "Polaroid" and “Polaroid and Pixel” are trademarks of Polaroid Corporation, Waltham, MA, USA.