Crown VRACK Operation Manual page 42

HiQnet™ Software
Designing and Recalling Presets
The VRack Preset Tab recalls the same preset numbers on all amplifiers; therefore, it is recommended you save system-specific presets by preset numbers.
Below is an example of how to set up a 3-Way + Sub VerTec 4889/4880 preset.
Step 1: Select output mode for the application. This example is a 3-Way + Sub.
Step 2: Open the device panel for the amplifier and load bandpass presets based on above Output Operation Mode.
Step 3: Recall Preset 4889/4880 VRACK from VRack Device Panel.
page 42
Open Preset: MF/HF 4889 into preset #2.
Rename Preset to 4889/4880 VRACK.
Load Preset: LF/LF 4889 4880 80 4889 into preset #2
(Crossover at 80Hz).
Rename Preset to 4889/4880 VRACK.
Load Preset: SUB/SUB 4880 4889 80 into preset #2
(Crossover set at 80Hz).
Rename Preset to 4889/4880 VRACK.
Operation Manual