Teledyne WaveStation 3000 Operator's Manual page 19

3. Adjust parameters
For all waveforms except Noise, adjust the values for:
Frequency or Period.
l
Amplitude and Offset, or absolute HighLevel and LowLevel of voltage.
l
For Sine waves, also adjust Phase.
For Square waves, also adjust:
Phase
l
DutyCycle, entered as the percentage of the High Level taking up the whole period.
l
For Ramp waves, also adjust Symmetry.
For Pulse waves, also adjust:
Width or Duty Cycle
l
Rise(ing Edge) or Fall(ing Edge)
l
Delay
l
For Noise waves, adjust:
Stdev
l
Mean
l
4. When all parameters are configured, press the appropriate Output button to output the waveform, or go on
to apply Modulation, Sweep, or
NOTE: Noise waves cannot be modulated or swept. Pulse waves cannot be swept.
S A :
EE LSO
Generating DC Waveforms
Generating Arbitrary Waveforms
Recalling Stored Waveforms
922869 Rev B
as necessary using either the Adjustment knob or the numeric keypad.
Burst signal conditioning before outputting.
Operator's Manual
13