CONSTRUCTA Washing machine Instruction Manual And Installation Instructions page 27

Fault
Foam comes out.
Motor noise
Pump noise
"Lid" button cannot be
pressed.
Vibrations during wash and
spin cycles p y
Repeated spinning
Programme runs for longer
than usual.
Washing result not
satisfactory. y
Cause
Too much detergent.
Not a fault.
Noises may be generated during the running in phase of the drive
motor.
Not a fault.
Noises generated when the pump starts up or draws air are normal.
Programme not ended or
"L" selected.
Transit bolts not removed
Appliance feet not secured.
Appliance standing on
rollers.
Not a fault.
Unbalanced load detection system attempts to remove an imbalance by
repeatedly spinning the washing.
Not a fault.
Unbalanced load detection
system attempts to remove
an imbalance by repeatedly
distributing the washing.
Foam detection function has
implemented an additional
rinse cycle to dissolve the
foam.
Soiling is greater than
assumed.
Insufficient detergent
dispensed.
Action
Switch off the appliance.
Mix 1 tablespoon of fabric softener with
½ litre of water and add to dispenser II.
Switch on the appliance again.
Reduce detergent dosing for the next
wash cycle.
When the water has been drained and
the programme has ended, the
appliance lid can be opened after
approx. 2 minutes.
Remove the transit bolts; see installation
instructions.
Secure the appliance feet.
Swivel the lever from left to right.
Wash large and small items of washing
together to reduce the imbalance.
Adjust detergent dosing for the next
wash cycle.
Select suitable programme.
Dispense detergent according to the
manufacturer's specifications.
27