Advertisement
Advertisement
Table of Contents
Related Manuals for DeLonghi PAC 35
Summary of Contents for DeLonghi PAC 35
- Page 1 Air-conditioner PAC 35 Instructions for use...
-
Page 2: Technical Data
In particular, refer to the safety warnings on page 24. INTRODUCTION TECHNICAL DATA The new PAC 35 consists of two units: the internal For this equipment’s technical features, read the unit is designed to operate inside the room to be plate listing those features. -
Page 3: Internal Unit
DESCRIPTION INTERNAL UNIT Connection hose Air outlet grid Control panel Tiemr cover (to adjust the timer, slide cover sideways) EXTERNAL UNIT INTERNAL UNIT Carrying handle ;;;; ;;;; ;;;; ;;;;; ;;;;; ;;;;; ;;;;; ;;;;; Removable filter ;;;; ;;;; ;;;;; ;;;;; ;;;; ;;;;; Air intake grille Rear panel Power cable space... - Page 4 ACCESSORIES ILLUSTRATION NUMBER SUPPLIED DESCRIPTION Wall bracket Screws + wall plugs (Ø 6mm) Nut and bolt (Ø 5mm) Support belt with hook Frame for connector hose Castor stop Condensation drainage coupling Castors for external unit and washers This appliance is fitted with a special HE (High Efficiency) system for extra-low energy consumption.
-
Page 5: Installation
In this case, it is necessary to disconnect the INSTALLATION internal unit as follows: MODELS WITHOUT SPECIAL COUPLINGS 1) Remove the plug from the wall socket. The hose which connects the internal unit to the 2) Remove the rear panel (on the back of the external unit can be positioned in two ways: appliance) by unscrewing the four retaining screws. - Page 6 To re-connect the ends of the connector hose to Alternatively, for temporary installation, the the internal unit, repeat steps 1 to 6 in reverse external unit can be hung as shown in the figure. order. The following precautions should be In this case, use the special support belts observed: (supplied with the appliance).
-
Page 7: Electrical Connections
• Draw the curtains and/or partially close the ELECTRICAL CONNECTIONS blinds to protect the room against direct sunlight. Before plugging the unit into the mains, check the This will increase the efficiency and economy following: of the air-conditioner. • the mains voltage must be the same as the •... -
Page 8: Control Panel
CONTROL PANEL ON/OFF button ON/OFF pilot light "Alarm" pilot light Timer ON/OFF pilot light Timer ON/OFF Selecting fan Thermostat Timer notches button speed button PROGRAMMED MODE SETTING THE TIMER 1) Release B TIMER button The programmer/timer, like all clocks, must be set to the 2) Set the operating times by pushing out the notches on exact time. - Page 9 HOW TO START UP THE CONDITIONER (see control panel on the opposite page) Plug the appliance into the mains. Select the "programmed" or "non programmed" mode (see previous page) Select the fan speed required pressing "Fan speed" key C. AIR-CONDITIONING Key A ON/OFF (Condition- ing) must be released Turn the thermostat to Max.
-
Page 10: Maintenance
MAINTENANCE AT THE END OF THE SEASON Switch off the appliance by pressing the ON/OFF key. Always remove the plug from the power Remove the plug from the drainage tube and socket before carrying out any cleaning or empty the water from the internal condensation maintenance operations. -
Page 11: Troubleshooting
TROUBLESHOOTING Most malfunctions are caused by a very minor and easily solved problem. Before contacting your nearest authorised Service Centre for assistance, consult the troubleshooting chart below. PROBLEM CAUSE SOLUTION • power failure • wait until the power supply is restored The air-conditioner does not function •...