Operating Sequence - Electrolux EWF860 Instruction Booklet

EWF860_UK.qxp 4/6/2006 3:51 PM

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the
ECO valve. Then run the cotton cycle 60°E, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out the prewash or a stain phase,
pour detergent into the appropriate compartment
marked .
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
Page 15
.
15
4. Select the desired programme
Turn the programme selector dial to the desired
position.
The light corresponding to the max spin speed for
the selected programme illuminates and the light of
the Start/Pause button starts to flash.
5. Select the required option(s)
The light corresponding to the depressed button
illuminates.
When selecting the Rinse Hold option the water of
the last rinse is not emptied out, to prevent the
fabrics from creasing.
6. Reduce eventually the spin speed
Press the Spin Reduction button repeatedly to
reduce the spin speed.
The relevant light illuminates.