Troubleshooting - Electrolux EHF6240XOK User Manual

www.electrolux.com
8
Scratches or dark stains on the
glass-ceramic cause no effect on
how the appliance operates.
To remove the dirt:
1. – Remove immediately: melted
plastic, plastic foil, and food with
sugar. If not, the dirt can cause
damage to the appliance. Use a
special scraper for the glass . Put
the scraper on the glass surface at
an acute angle and move the blade
on the surface .

6. TROUBLESHOOTING

You cannot activate the
appliance or operate it.
The appliance deactivates. You put something on the
The residual heat indicator
does not come on.
The sensor fields become
hot.
comes on.
comes on.
and a number come
on.
Problem
2.
3.
Possible
You touched 2 or more
sensor fields at the same
time.
There is water or fat stains
on the control panel.
sensor field .
The cooking zone is not
hot because it operated
only for a short time.
The cookware is too large
or you put it too near to
the controls.
The Automatic Switch Off
operates.
The Child Safety Device
function operates.
There is an error in the ap-
pliance.
– Remove after the appliance is
sufficiently cool: limescale rings ,
water rings, fat stains, shiny metallic
discolorations. Use a special clean-
ing agent for glass ceramic or stain-
less steel.
Clean the appliance with a moist cloth
and some detergent.
At the end rub the appliance dry
with a clean cloth.
Remedy
Activate the appliance
again and set the heat set-
ting in less than 10 sec-
onds.
Touch only one sensor
field.
Clean the control panel.
Remove the object from
the sensor field.
If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
Put large cookware on the
rear cooking zones if nec-
essary.
Deactivate the appliance
and activate it again.
Refer to the chapter "Op-
erating instructions".
Disconnect the appliance
from the electrical supply
for some time. Disconnect
the fuse from the electrical
system of the house. Con-
nect it again. If
on again, speak to the
service centre.
comes