To Change The Light Bulb; When The Appliance Is Not In Use; Something Not Working - Electrolux ER8207C Instruction Booklet

Hide thumbs Also See for ER8207C:
Table of Contents

Advertisement

To Change the Light Bulb

The light is switched on automatically when the
door is opened. Before replacing the light bulb,
disconnect the power plug from the outlet.
Fold the grille backward by unsnapping the front
edge.
Use a bulb of the same type, E14 socket, maximum
rating of 25 W.
When replacing the light bulb, use a bulb of the
same type as the original one. The glass must
measure at least 18 mm in diameter at the socket.
This will ensure close fitting of the bulb against the
rubber seal in the socket.

When the appliance is not in use

Disconnect the appliance from electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to
check it once in a while to prevent the food inside
from spoiling in case of a power failure.

Something Not Working

Before contacting your local Service Force Center check the following point:
Problem
It is too warm inside the refrigerator.
It is too cold inside the refrigerator.
There is water on the cooling plate inside
the refrigerator.
Water is running inside the refrigerator.
Water comes out on the floor.
Possible cause / Remedy
Set a lower temperature.
Put food products in the right place inside the refrigerator. See
the chapter "Temperature inside the refrigerator".
Distribute the food products to allow cold air to circulate
around them.
Make sure that the door is completely closed and that the
insulating strip is complete and clean.
The temperature where the cabinet is placed is above normal
room temperature.
Set a higher temperature.
Vegetables and other products that are easily frozen have been
placed on a "too cold" shelf. See the chapter "Temperature
inside the refrigerator".
This is normal. During automatic defrosting, frost thaws on the
cooling plate.
Clean the water drain and drain hole inside the refrigerator
using e.g. cotton swabs or a bottle cleaner brush.
Some food products could have been placed causing the water
from running into the drain.
Place the drain hose at the back of the cabinet above the drain
bowl. See the chapter "Before using the cabinet the first time".
14
GB
Electrolux 818 17 33-00/0

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents