Table of Contents
Advertisement
INSTALLATION
If this appliance featuring magnetic door seals is
to replace an older appliance having a spring lock
(latch) on the door or lid, be sure to make that
spring lock unusable before you discard the old
appliance.
This will prevent it from becoming a death-trap for
a child.
Positioning
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct sun-
light etc.; best performance is obtained with ambient
temperature between +16 C and +32 C (class N) or
between +10 C and +32 C (class SN). The class of
your appliance is shown on its rating plate.
For building into kitchen units follow the special
"Building-in" instructions given.
Electrical connection
Before plugging in, ensure that the voltage and fre-
quency shown on the serial number plate correspond
to your domestic power supply.
Voltage can vary by 6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a con-
tact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in compli-
ance with current regulations, consulting a specialist
technician.
The Manufacturer declines all responsibility if the
above safety precautions are not observed.
This appliance complies with EEC directive
number 87/308 of 2/6/87 relative to radio inter-
ference suppression.
This appliance complies with the following
E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibil-
ity Directive) and subsequent modifications.
Cleaning the interior
Before using the appliance for the first time, wash the
interior and all internal accessories with lukewarm wa-
ter and some neutral soap so as to remove the typical
smell of a brand-new product, then dry thoroughly.
Do not use detergents or abrasive powders, as these
will damage the finish.
Instructions for totally built-in appliances
Dimensions of the recess
Height
880 mm
Depth
550 mm
Width
560 mm
The appliance's door has been locked in position
for transport by means of pins on both sides. Ac-
cording to the door opening direction, remove rel-
evant pins at the top and at the bottom.
For safety reasons, minimum ventilation must be as
shown in Fig. 1.
Attention: keep ventilation openings clear of ob-
struction.
50 mm
D567
A
D022
A
D265
Fig. 1
min.
cm
2
200
Fig. 2
P u s h a p p l i a n c e
into the housing
until stop strip (A)
touches the kitch-
en unit.
Fig. 3
If after having car-
ried out the previ-
ously described op-
eration there is still
some space left be-
tween the appli-
ance and the kitch-
en unit, fit the trim-
ming provided to-
g e t h e r w i t h t h e
appliance on the
stop strip (A).
29
Advertisement
Table of Contents
