Installation; Electrical Connection - Electrolux ENB3660 Instruction Book

Installation

Positioning
• Place the refrigerator away from direct sunlight and
heat sources.
• Take off at least 50 mm. free over the appliance.
• Never put something on the ventilator of the applian-
ce. (see fig. 1).
• Make sure the refrigerator is accurately levelled tur-
ning the adjustable feet on the front, in order to avoid
vibrations and noises and to make sure that the doors
shut properly (see fig. 2).
• Before placing the plinth cover, pull out the fixing
part of doors used only for security during transport
(see fig. 3).
• With the freezer door wide-open, assemble the socle
provided inside the appliance, following the instruc-
tions stuck on it.
• Remove the shelves transport fastening red pieces
by sliding them (see fig. 4).
• The appliance should not be located in places with
maximum temperatures more than:
+ 32°C for N/SN Class (classification on rating
plate).
+ 43°C for T/ST Class (classification on rating
plate).
If the temperatures are higher than those mentioned
above, the functioning and the safety of the applian-
ce could be affected.
Cleaning the interior
• Do not use alcohol or any cleaning produts contai-
ning alcohol because they could damage the plastic
parts of the appliance.
• Before using the appliance for the first time, wash
the interior with luke warm water and a neutral soap.
This will help to remove the typical smell of a new
fridge/freezer. Afterwards dry thoroughly.
• Do not use detergents or abrasive powders as these
will damage the finish.
• Remove security elements used for transportation.

Electrical connection

mBefore plugging the appliance into a socket make
sure that the voltage and frequency shown on the
rating plate correspond to your home supply. (see
fig. 5).
It is essential that the appliance should be properly
earthed.
mFor this purpose the supply cable plug incorporates a
special earth contact. If the sockets of your domestic
wiring system are not earthed, have the appliance
connected to a separate earth wire in accordance
with existing safety regulations.
4
Fig. 1
Fig. 2
Fig. 3
Fig. 4