Electrolux EWD 1477 Instruction Booklet page 12

If you have already pressed the "Start/Pause" button,
and you wish to cancel the delay time, proceed as
follows:
• set the machine to PAUSE by pressing the
"Start/Pause" button;
• press the "Delay Start" button until the symbol
« » is displayed.
0'
• press the "Start/Pause" button again.
Important!
• The "Delay Start" cannot be used with "Drain",
"Spin" or "Delicate Spin" programmes.
9 "Start/Pause" button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the machine. The light above the button will stop
flashing and remain lit.
If you have selected a delay time by means of
"Delay start" button, the countdown will begin and
will be shown on the display.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, and it becomes
possible to open the door, it means that:
• the machine is not in the heating or drying phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the machine to PAUSE before you
make any change in the programme in progress.
10 DISPLAY
The following pieces of information are shown on the
display:
• Duration of washing programme in hours and
minutes, after you have selected a programme (for
example 2.05).
The duration is calculated automatically on the
basis of the maximum recommended load for each
type of fabric.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
• The washer-dryer has stopped with water in the
tub, at the end of a programme with
selected: this is indicated by a flashing zero.
• The washer-dryer has completed the
programme: this is indicated by a flashing zero.
After starting the programme, the remaining time is
updated every minute.
12
option