Operating The Hob; Touch Control Sensor Field; Switching On The Appliance; Switching Off The Appliance - Electrolux EHD 8680 X Installation And Operating Instructions Manual

Operating the Hob

ng the Hob

Touch Control Sensor Field

To operate the Touch Control sensor field place your
finger from above flat onto the required field until the
appropriate displays come on or go out or the re-
quired function is carried out.

Switching On the Appliance

The entire appliance is switched on using the "On/
Off" n sensor field.
Touch the "On/Off" sensor field for approx. 2 sec-
onds.
The digital displays will show j and the decimal
point will flash.
3
Once the "On/Off" sensor field has been oper-
ated to switch on the appliance, one of the
cooking zones must be selected within ap-
prox. 10 seconds using the cooking zone se-
lection buttons. Otherwise the appliance
switches off again for safety reasons.

Switching Off the Appliance

To switch off the appliance completely activate the
"On/Off" n sensor field.
Touch the "On/Off" sensor field for approx.
1 second.
3
When an individual cooking zone or the entire
hob is switched off, any residual heat is shown
with an h (for "Hot") in the digital display for
the appropriate cooking zones.

Cooking Zone Selection

To select the required cooking zone touch the corre-
sponding sensor field for approx. one second.
A zero with a decimal point will light up in the appro-
priate cooking zone display window 0.
3
The decimal point indicates that settings may
only be made for this cooking zone.
12
Field