Electrolux EWN 820 Instruction Booklet page 9

RINSE HOLD position
option, the machine will not drain the water of the
last rinse, so as not to wrinkle the laundry.
At the end of the cycle the door is locked, the light
of the START/PAUSE button goes off, the pilot
lights and remain lit, to indicate that the
water must be drained.
To complete the cycle, choose one of the following
options:
• Drain :
Press the SKIP/RESET button once, all the leds are
off, then press button in order to select the
desired programme. If you wish to drain
spin press SKIP/RESET button until the led of
the desired function remains lit.
You can change the spin speed by means of
button and then depress START/PAUSE button .
Important! If you accidentally press the RESET
button more than once, the programme is cancelled.
To cause the washing machine to drain the water,
select any washing programme by means of the
FABRIC button , then press RESET three times
in order to select the DRAIN
DRAIN light will light up).
6-7 OPTIONS buttons
Press these buttons to select the following options:
• PREWASH : select this option if you wish your
laundry to be prewashed before the main wash
(not available for wool and handwash).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics,
whereas in the programme for delicate fabrics the
water is only drained.
• QUICK WASH : for laundry that is only slightly
soiled (not for wool and HAND WASH
programme).
The washing time will be reduced according to the
type of fabric and the selected temperature.
The PREWASH and QUICK WASH options
cannot be selected together.
• ECONOMY : this option can be selected only
for cottons and synthetics lightly or normally
soiled with a temperature 40°C or higher. The
washing time will be prolonged and the washing
temperature will be reduced.
: when you choose this
or to
position (only the
8 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired
programme and options, press this button to start
the washing machine. The light above the button
will stop flashing and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light
above the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the
programme in progress.
9 SKIP/RESET button
At the end of a programme, you must press this
button once or repeatedly, in order to clear the
contents of the memory; otherwise, the next time
you switch the washing machine on, the pilot lights
relevant to the end of the previous cycle will go on.
You can also press the RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by pressing
the START/PAUSE button (the relevant light will
flash);
- press the RESET button once or several
times, until the required phase(s) is(are) cancelled
(the light next to the symbol of the phase(s) will go
out).
Example:
/
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it
has just performed a washing programme, proceed
as follows:
9
In this case, the spin
(at the speed provided
for the selected type of
fabric) will be
performed.