Table of Contents
Advertisement
Building-in
This dishwasher is designed to be fitted under a kitchen
counter or a worksurface.
It is essential that the recess dimensions indicated in the
illustration are followed.
No further openings for venting of the dishwasher are required,
but only to let the water fill and drain hose and power supply
cable pass through.
The height of the recess where the dishwasher is to be
installed can vary between 820 and 880 mm from the floor
since the dishwasher is fitted with adjustable feet (max. 60
mm).
Leave a space of 2 mm between the top of the dishwasher and
the underside of the kitchen counter.
Adjusting the height of the dishwasher
The dishwasher incorporates adjustable feet to allow the
adjustment of the height.
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw in the middle of the
front kick plate to the left or to the right.
Good levelling is essential for correct closure and sealing of
the door. When the appliance is correctly levelled, the door will
not catch on the levelling spacers on either side of the cabinet.
If the door does not close properly, loosen or tighten the
adjustable feet until the machine is perfectly level.
If there is a space at the
bottom of the machine,this
can be covered by lowering
the plinth.
Fitting the vapour protection
Screw the vapour protecting
strip onto the front part of the
worktop. Use 4 screws (3.5 x
16 mm) as shown in the
illustration.
Fitting the sealing strips to the sides of
the appliance
To ensure closer contact with
adjacent kitchen units, fit the
plastic sealings strips down
both sides of the front of the
machine before inserting it
into the recess.
Fixing to the adjacent units
Tighten the screws so that the dishwasher cannot tip forward
and cause damage when the door is open and loaded.
Secure the dishwasher by screwing it firmly in position under
the bench or to the cupboard beside it. Use the angular
brackets supplied which are fitted into the slots on the top of
the dishwasher (see fig.).
Tighten the machine in position (upwards or sideways) by
using the screws supplied (3.5 x 16 mm).
II54
The dishwasher must be secured to the underside
of the worktop or to adjacent units by using the
brackets supplied.
Neglect to do this can cause injury or damage.
Under no circumstances may holes be drilled
through the sides of the dishwasher since this
could damage the hydraulic components.
18
6 0 0 m m
II25
A
A
A
A
II23
Hide quick links:
Advertisement
Table of Contents
