Use - Drying - Electrolux EWW 147470 W User Manual

12 electrolux
water must be emptied out before opening
the door.
Before you empty out the water, the drum
continues to run at regular intervals until the
water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to O.
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of

USE - DRYING

DRYING ONLY
Warning!
The recommended load size is 3.5 kg for
cottons and linen and 2 kg for synthetic
items.
By pressing Drying Time button it is
also possible to dry up to 5 kg of cot-
ton items (see the «Drying Pro-
gramme » table).
Warning!
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum
spin speed allowed for the type of laun-
dry in order to obtain the best drying
performances.
3. Select the drying programme for Cot-
tons or Synthetic in the Drying sector of
the programme selector dial.
4. If you wish to select an automatic dry-
ing press the button 5 until the light
corresponding to the required dryness
degree illuminates.
4. Press button 8.
At the end of the programme, the door is
released and can be opened. Turn the pro-
gramme selector dial to O to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
5. If you wish to select a timed drying,
press the button 5 until the time you
want appears on the display (see the
«Drying Programme» table). Every time
you press this button the drying time in-
creases by 5 minutes.
Note!
The programme time will automatically
increase by some minutes.
6. Press button 8 to start the programme.
The time remaining is updated every
minute.
7. At the end of the programme, the buz-
zer sounds. Three blinking «0.00» zeros
appear on the display.
During the last 10 minutes of the drying
cycle the appliance performs an anti-
crease phase. Through this time the
door is locked. The display shows three
flashing zeros «0.00».
If you wish to open the door before or
during the anti-crease phase or to in-
terrupt it, press any button or turn the
programme selector dial to any pro-
gramme position (except O).
8. Turn the selector dial to the O position
to switch the machine off.
9. Remove the laundry from the drum.
Note!
The different type of cottons (towelling,
sheets, shirts, and so on) or any laundry
items rolling up during the spinning phase
may result in partial dryness. In the excep-
tional case that at the end of the cycle the