Operating Sequence; Washing Only; Load The Laundry; Measure Out The Detergent And The Fabric Softener - Electrolux EWD 1419I Instruction Booklet

Operating Sequence

Washing only

Before the first wash, we recommend that you run a
cotton cycle at 95°C, without any laundry in the
machine, to remove any manufacturing residue from the
drum and tub.
Pour 1/2 a measure of detergent into the main wash
compartment of the dispenser drawer and start the
machine.

1. Load the laundry

Open the door by pulling the door handle outwards.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the door.
2. Measure out the detergent
and the fabric softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required and pour
it into the main wash compartment
If you have selected the
into the compartment marked
If required, pour fabric softener into the compartment
marked (the amount used must not exceed the
"MAX" mark in the drawer). Close the drawer gently.
«JETSYSTEM» wash
As the Jetsystem is flexible and adjusts water intake
according to wash load size it is not possible to give you
exact recommandations as to the amount of detergent
that should be used for any one wash.
.
option, pour detergent
PREWASH
.
Therefore we recommend that you use approximately
1/3 less than the detergent manufacturer recommends on
the packet or bottle, making the appropriate allowances
for soft or hard water, and light or heavy soilage of
clothes. If you have judged the amount correctly you
should expect to see a soft sudsy liquid during the wash.
It is not necessary to have a head of lather on the water.

3. Switch the machine on

To switch the machine on, press the O
mains-on light comes on. The display will show three
flashing dashes or a blinking zero.
If the programme selector dial is on the Reset Off
position, three flashing dashes will be displayed. If the
programme selector dial has been left on a wash
programme position at the end of the previous washing
cycle, a flashing zero appears on the display.

4. Select the required programme

Turn the programme selector dial to the desired
position: the lights corresponding to the different phases
making up the selected programme light on.
The display shows the duration of the programme.
11
/O button: the
N FF