Installing Fan To Wind Tunnel Assembly - Abit SI-2PA User Manual

Hardware Setup
2.3.4.

Installing Fan to Wind Tunnel Assembly

1. Attach the cooling fan with its airflow direction pointed to heatsink to the air
intake portion of wind tunnel.
2. Attach the air intake assembly to the side of the wind tunnel nearest to the front of
the chassis.
Instead of attaching cooling fan to the side of the wind tunnel, the fan itself could
also be attached to the top of the center portion of wind tunnel.
3. Align the tabs on the assembly with the slots in the wind tunnel portion, and then
snap the lower portion of the fan holder over the tabs on the center portion.
4. Attach the air outlet portion of the wind tunnel.
5. Attach CPU Fan 1 power cable to the server board at location FAN1 and/or attach
CPU Fan 2 power cable at location FAN2.
NOTE: The system airflow should be toward the front of the chassis. If there are two
processors installed, the fans should be positioned side by side.
2-5
User's Manual