Related Manuals for Steam Planet MG-305
Summary of Contents for Steam Planet MG-305
- Page 1 Installation and Operation Manual MG-305 120V, 30a Please read this manual carefully before use. Page 1...
- Page 2 Important Safety Instructions: Warning! Use this unit only for its intended purposes or as described in this manual. Use only attachments recommended by the manufacturer. Risk of hyperthermia and possible drawing. Water temperature in excess of 38°C may be injurious to your health. Check and adjust temperature before use. Read and Follow all Instructions ...
- Page 3 Unpacking the Unit 1. Inspect the carton, if carton damage is noted: take a picture if possible, notify the deliverer. 2. NEVER LIFT THE TUB BY THE PLUMBING. Doing so can result in leaks, for which the installer is responsible. 3.
- Page 4 Note: IF the pumps do not operate: a. Check the breaker to insure power is on and the cable connecting the controls to the pump is attached b. If an optional heater is present, check the indicator light on the heater to insure that power is present.
- Page 5 Page 5...
- Page 6 Page 6...
- Page 7 Installation Preparation 1. Check the floor area where the tub is to be installed a. Clean area of any debris or trash b. Use a 5 or 6-foot level and determine if the floor is leveled. If the floor is not leveled, adjust all 5 leveling feet to perfectly level the tub.
- Page 8 Installation Procedures: Warning: When installing jet massage baths, air massage baths, or dual baths, basic precautions should be followed, including: Danger: Risk of electrical shock. Connect only to a separate circuit protected by a group fault circuit interrupter (GFCI) ...
- Page 9 Operating Instructions: 1. Enter the Walk-in Tub, close the door and fill the bath at least 3 inches below the overflow before activating the pump. 2. The pump will be activated by the on/off control. Each depression of the button changes cycles.
-
Page 10: Troubleshooting
Troubleshooting: Phenomenon Reason Solution 1. Make sure the power is 1. Power plug is not plugged in all the way. plugged in all the way 2. Find & remove short 2. Residual Current circuit, then connect Protective device is off the protection switch. - Page 11 Cleaning and Maintenance: Pump and pipe circulation system should be flushed before first use and on a monthly basis when product is under normal use. Below are the recommended procedures for cleaning: Do not run whirlpool dry. Fill the tub with hot water 2-3 inches above the jets and add 2-3 teaspoons of low foaming detergent suck as dishwashing machine detergent.
Need help?
Do you have a question about the MG-305 and is the answer not in the manual?
Questions and answers