Status Request Commands; Parameter Format; Command Example - Panasonic PT-VX415NZ Manual

LCD Projectors

Status request commands

Command Description
QPW Standby power status
*
Q$S Lamp status
*
Input signal status
QIN
QPM Picture mode status
Q$L Lamp run time
QAV Volume adjustment value
* These commands are effective when the standby mode is set to eco. (Other commands are not effective.)
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.

Parameter format

Parameter format Size (Byte)
3 (1 or 2 bytes also
<pl>
possible when
under control)
1
<off on>
3
<input signal>
3
<power condition>
1
<lamp condition>
4
<acctch>
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.

Command example

To set the volume to +30, send the command as shown below.
STX
Start
NOTE: When sending commands without parameters, a colon (:) is not necessary.
As of October 2013
SFL13M008
Standard
Dynamic
Cinema
Real
Blackboard
Colorboard
Image 1
Image 2
Image 3
Image 4
Definition
Decimal without signs: 0 to 999 (000, 001, 002...999)
Decimal with signs: -99 to +99 (-99...-01, +00, +01, +02...+99)
Callback from the projector is 3 Byte.
0 = off, 1 = on
HD1 = HDMI, RG1 = computer 1, RG2 = computer 2, NWP = network
PA1 = memory viewer, MG1 = panasonic application, MV1 = Miracast,
VID = video, SVD = S-Video
000 = power off (standby mode off), 001 = power on (standby mode on)
0 = standby, 1 = lamp on under control, 2 = lamp on,
3 = lamp off under control
Decimal without signs: 0000 – 9999 hours
AVL : 30
Command Parameter
Callback
<Parameter>
<power condition>
<lamp condition>
<input signal>
STD
DYN
CIN
REA
BBD
CBD
IM1
IM2
IM3
IM4
<acctch>
<pl>
ETX
End
PT-VX415NZ
1 2 / 1 4