Operating Sequence - Electrolux EWF 705 Instruction Booklet

Operating sequence

Before the first wash we recommend that you pour 2
litres of water into the main wash compartment
of the detergent drawer in order to activate the
ECO valve. Then run a cotton cycle at 90°C, with the
machine empty, in order to remove any
manufacturing residue from the drum and tub.
Pour half a measure of detergent into the main wash
compartment and start up the machine.
1. Place the laundry in the drum
Open the door.
Place the laundry in the drum, one item at a time,
shaking them out as much as possible.
Close the door.
2. Measure out the detergent
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent recommended by the
manufacturer in a graduated cup and pour it into the
main wash compartment
If you wish to carry out a programme with prewash,
pour detergent into the appropriate compartment
marked .
3. Measure out the additive
If required, pour fabric softener into the compartment
marked , without exceeding the «MAX» mark.
.
4. Select the desired option(s)
Depress the required button(s).
5. Select the temperature
Turn the dial to the required setting.
6. Select the programme and start the
machine
Turn the programme selector dial clockwise to the
required programme and press the ON-OFF button:
the mains on light comes on and the machine starts
to operate.
7. At the end of the programme
The machine stops automatically. The mains-on light
goes out.
If you have selected programmes 7-8-9-10-11, the
machine will stop with the water left in the tub, to
prevent the fabric from creasing. To drain the water
and spin, select programme 12 (short spin). To drain
only, select programme 13.
The door is controlled by a safety device which
releases 2 minutes after the end of the programme.
Switch the machine off by depressing the ON-OFF
button again.
When the programme has finished you are advised
to unplug the appliance and turn off the water tap.
11