Table of Contents
Advertisement
Rear spacers
The plastic bag containing all relevant
documentation also contains two spacers to be fitted
into special holes in the back of the appliance. Fit the
spacers into the holes, taking care to ensure that the
arrow (A) is positioned as shown in Figure. Then turn
them through 45° (arrow (A) vertical) until they lock
into place.
Door reversal
Unplug the appliance before all operations.
To reverse the door, proceed as follows:
1. dismantle the lower hinge (1), and the support
foot (2);
2. unscrew the left front foot (3) and reposition on
the opposite side;
3. slide the door out from pin (G),unscrew the pin
and reposition on the opposite side;
4. unscrew the two screws which mask the holes for
fixing the hinge from the left front side;
5. reassemble the door;
6. reassemble the lower hinge (1), and the support
foot (2) on the opposite side;
7. dismantle the handle and reassemble it on the
opposite side.Cover the holes left open with the
plugs contained in the documentation pack.
Warning:
After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet. If the ambient temperature is cold (i.e.
in Wınter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdrier.
38
A
45°
PR60
G
3
1
2
D715 PIED/M
PR228
15
Advertisement
Table of Contents
