Download Print this page

Lighting Instructions; To Turn Off Gas To Appliance - Rheem Versa Spa Heaters Operating Instructions Manual

Operating instructions
Hide thumbs Also See for Versa Spa Heaters:

Advertisement

A. This appliance has a pilot that must be lighted by
hand. When lighting the pilot, follow these
instructions exactly.
B. BEFORE LIGHTING smell all around the appli-
ance area for gas. Be sure to smell next to the
floor because some gas is heavier than air and
will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
*Do not try to light any appliance.
*Do not touch any electric switch; do not use any
phone in your building.
*Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instruc-
tions.
1. STOP! Read the safety information above.
2. Set the thermostat on the lowest setting.
3. Turn On-off switch to the "Off" position.
4. Remove heater door panel.
5. Push in gas control knob slightly and turn clock-
wise
to "Off".
NOTE: Knob cannot be turned from "Pilot" to
"Off" unless knob is pushed in slightly. Do not
force.
6. Wait 5 minutes to clear out any gas. If you then
smell gas, STOP! Follow "B" in the safety
information above. If you don't smell gas, go to
the next step.
7. Locate pilot mounted on the left side of the
burner tray. For burner tray location,
see General Location of Controls section,
page 17.
Gas control knobs shown in "Off" position
HONEYWELL
GASVALVE
MILLIVOLT
1. Set the thermostat to the lowest setting.
2. Turn On-off switch to the "Off" position.
3. Remove heater door panel.
LIGHTING INSTRUCTIONS AND SHUT-OFF PROCEDURES
MANUALLY LIGHTED PILOTS
(MILLIVOLT SYSTEM)

LIGHTING INSTRUCTIONS

ROBERTSHAW
GAS VALVE
MILLIVOLT

TO TURN OFF GAS TO APPLIANCE

*If you cannot reach your gas supplier, call the
fire department.
C. Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
push in or turn by hand, do not try to repair it. Call
a qualified service technician. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to re-
place any part of the control system and any gas
control which has been under water.
ROBERTSHAW PILOT
8. Turn knob on gas control counter-clockwise
to "Pilot".
9. Push in control knob all the way and hold in.
Immediately place flame to pilot to light.
Continue to hold control knob in for about 1
minute after the pilot is lighted, release knob
and it will pop back up. Pilot should remain
lighted. If it goes out, repeat steps 5 through 9.
*If knob does not pop up when released, stop
and immediately call your service technician
or gas supplier.
*If the pilot does not stay lit after several tries,
turn the gas control knob to "Off" and call your
service technician or gas supplier.
10. Stand to the side of the heater and turn the gas
control knob counter-clockwise to
11. Replace heater door panel.
12. Turn On-off switch to the "On" position.
13. Set thermostat to the desired setting.
4. Push the gas control knob slightly and turn
clockwise to
5. Replace heater door panel.
HONEYWELL PILOT
"On".
"Off". Do not force.

Advertisement

loading