Download Print this page

NEC LCD19WV User Manual page 6

Hide thumbs Also See for LCD19WV:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
OSD Setup
H. Position
Adjusts the horizontal position of the OSD.
V. Position
Adjusts the verticalposition of the OSD.
OSD Timeout
Adjusts the OSD timeout.
Language
Language
Sets OSD language.
Information
Information
Shows the resolution, H/V frequency, serial number and
input port of current input timing.
Reset
Yes
Clear each old status of Auto-configuration.
No
Do not execute reset, return to main menu.
Exit
Exits OSD.
01_English
OSD Message:
Auto Config Please Wait
If User Press Hot-Key "Auto", will show this message, and the monitor
do the auto configuration function.
This message location is at the position setting in "OSD Setup" item.
Input Not Supported
When the H sync Frequency, V sync Frequency or Resolution is out
of the monitor support range, will show this message. This message
will be flying.
Cable Not Connected
When the video cable is not connected, will show this message.
This message will be flying. After 5 seconds, the monitor will enter
power saving.
No Signal
When the video cable is connected, but there is no active signal
input, will show this message, after 5 seconds the monitor will enter
power saving. This message location is at the position setting in
"OSD Setup" item.
OSD Locked
When the OSD is unlocked, keep holding down "Menu" key and press
"Power" key once to turn on the monitor, the OSD will be locked and
show this message. When the OSD is locked, only Power key function
is still working, if user presses any other key it will also show this
message. When the OSD is locked, Keep holding down "Menu" key
and press "power" key once to turn on the monitor, the OSD will be
unlocked and will not show any messages. This message location is
at the position setting in "OSD Setup" item.
DDCCI Disable/Enable
When DDCCI is enable, press "Auto" key, after 5s the monitor will
show "DDCCI Disable" message.
When DDCCI is disable, press "Auto" key, after 5s the monitor will
show "DDCCI Enable" message.
This message location is at the position setting in "OSD Setup" item.
English-4
4
24/9/07, 5:06 PM

Advertisement

loading

This manual is also suitable for:

Lcd22wv