Table of Contents
Advertisement
12 DELAY START button
This button makes it possible to delay the starting of
the programme selected from 30 min - 60 min - 90
min, 2 hours and then by 1 hour up to a maximum of
23 hours. The delay you have selected is shown on
the display for about 3 seconds; afterwards, the
duration of the programme reappears.
You must select this option after you have set the
programme and before you press the
START/PAUSE button.
The time value shown on the display will decrease
by one unit every hour.
You can change the delay time at any moment,
before you press the START/PAUSE button.
If you have already pressed the START/PAUSE
button, and you wish to cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by pressing the
START/PAUSE button;
• press the DELAY button twice, to erase the delay
time. The display will indicate «
• press the START/PAUSE button again.
Important!
The door will be locked throughout the delay time
(DOOR phase indicator light lit).
If you need to open the door, you must first set the
machine to PAUSE by pressing the START/PAUSE
button. After you have closed the door, press the
START/PAUSE button again.
».
0'
14
13 Programme phase indicator
lights
When you select a programme, the lights relevant to
the phases that form the programme light up.
Door indicator light
This light goes on when you press the
START/PAUSE button to start the selected
programme. It goes out during a cycle, if the water
level is above the bottom edge of the door or the
heating phase is beyond 55ºC.
At the end of a cycle the DOOR indicator light is out.
If the light DOOR is out during a cycle, and you set
the machine to PAUSE, the light starts to blink to
indicate that the door is not openable.
If the light DOOR is on during a cycle, set the
machine to PAUSE before open the door (the DOOR
indicator light goes out).
After you have started
the programme, only the
light relevant to the
phase that is currently
being carried out will
remain lit.
Advertisement
Table of Contents
