Monogram 36 Owner's Manual page 22

Type 2 bulb NOTE: Before replacing the bulbs, review
the light bulb information and WARNING
replacement
on page 20.
Replacing Type 2 bulbs in lamps located inside
the light shield at the top of the fresh food
compartment:
1. Set the Master Light switch to the OFF
2. If the Water Filter Cartridge is installed,
3. Holding the light shield with one hand,
4. Remove the 4 screws securing the light
5. Lower the light housing at the front, then
6. Turn the lamp
NOTE: Always follow bulb manufacturer's
directions for handling and replacing bulbs.
7. Remove the bulb by holding the base and
WARNING –
must be replaced or the heat from the bulb
could damage the refrigerator.
AVERTISSEMENT :
Vous devez remettre en place les écrans
protecteurs des ampoules pour ne pas
endommager votre réfrigérateur avec la
chaleur produite par les ampoules.
22
position (see Using the Master Light switch)
and allow the lamps to cool.
remove it and replace with the filter
bypass plug.
rotate the support tabs until they clear the
front of the light shield. Then push back on
the light shield, lower the shield at the front
and take out.
housing to the ceiling. There are two screws
at the front and two at the back.
pull it toward you so the tabs at the back of
the light housing come out of the slots on
the back wall. The lamp assemblies will
release from the holders.
protector to
access the bulb.
pulling straight out. Replace with a new bulb
and replace the lamp protector.
Lamp protectors
Care and Cleaning
Built-In Refrigerators
Support tabs
Screws
Slots
8. Holding up the light housing, place each
lamp assembly in its holder. Feed the
attached wires through the slots and tuck
the wires outside the side of the light
housing.
9. Insert the tabs on the back of the light
housing in the slots on the back wall.
Raise the light housing into position and
secure with the four screws.
10. Replace the light shield and rotate the
support tabs back out so they support the
front of the shield.
11. Remove the filter bypass plug and replace
with the Water Filter Cartridge. Reset the
Master Light switch to the ON position.
Upper light
shield
Screws
Light housing