Monogram 36 Owner's Manual page 10

Dispenser How it Works
with
The electronic controls on the dispenser are
glass-touch
truly interactive. The control panel is equipped
with a proximity sensor that causes the panel
controls
to light up as you approach the dispenser
(approx. 2 inches). To make a selection,
simply touch the graphic for the feature you
want, and the halo for that feature will light
up. When you walk away from the refrigerator,
the lighted graphics switch off automatically.
How to Use
To dispense water or ice: select WATER
CUBED ICE
Then press the glass gently against the
top of the dispenser cradle.
The spill shelf is not self-draining. To reduce
water spotting, the shelf and its grille should
be cleaned regularly.
If no water is dispensed when the refrigerator
is first installed, there may be air in the water
line system. Press the dispenser cradle for at
least two minutes to remove trapped air from
the water line and to fill the water system.
To flush out impurities in the water line,
throw away the first gallon of water.
CAUTION:
or any other objects into the ice crusher
discharge opening.
Locking the Dispenser:
Touch CONTROL LOCK for
3 seconds to lock the dispenser
and control pad. To unlock,
touch it again for 3 seconds.
10
,
or CRUSHED ICE .
Never put fingers
Ice & Water Dispenser
Built-In Refrigerators
Spill Shelf
Dispenser Light:
This feature turns the night light
on and off. The light also comes
on when the dispenser cradle is
pressed. If this light burns out,
it should be replaced with a 6 watt
12V maximum bulb. The bulb is
available through GE Parts and Accessories,
800.626.2002. Order part number WR02X10675.
Door Alarm:
To turn the Door Alarm feature
on, touch DOOR ALARM once.
To turn it off, press it again.
When the DOOR ALARM
is active, the alarm will flash and beep if you
keep the door open for more than 2 minutes.
(on some models)