Panasonic VIERA TC-P50G20 Operating Instructions Manual page 41

Check that the Network settings are as shown below, and then start "Connection test".
d_ Select "Connection test" and press OK _2_Displayed Connection test screen
(It takes a while to cancel the test.)
_ Complete Connection test
Success->Completion screen is displayed.
Error-->Follow the directions on screen to complete the setting.
Ifyouperform theProxy s ettings, check theProxy address a ndtheProxy p ortnumber.
Select Network type (Ethernet cable/Wireless (WiFi))
This setting is performed only when "Wireless (WiFi)" is selected in "Network connection" above.
Press "Wireless network", displayed screen
(only when "---", "No adapter" or "None" is displayed)
Set the following connection.
Please select the connection with your wireless LAN adapter and Access point.
_) Follow the directions on screen to complete the setting
WPS (Wi-FiProtectedSetupusingpush button):
Wi-FiProtected Setup is aneasysettingof the Wi-Fi A lliance'scertification.
Youcan connectthe Accesspoint to pressthe buttons.
WPS (Wi-FiProtectedSetupusingPIN number):
Setthe PINcode thatis displayed on the TV on theaccesspoint.
wPs (Wi.Fi Protected Setup using push b utton) (Formore detailson settingof Accesspoint,pleasereferto operating
manual f or the Accesspoint.)
Searchfor wirelessnetworks:
Selectan accesspointfrom the onessearchedfor automatically, and
configurethesettingsas instructedon the screen.
Manualsettings:
ManuallysetSSID, Securitytype, andEncryptiontype to matchthe
settingsofthe accesspoint towhich to connect.
When connectingby11n(5 GHz),select"AES"as the Encryption type for
the wirelessLAN.
• Displayed Connection status with an Access point
- - - : Connect with LAN cable
No adapter: Wireless LAN adapter is not installed.
None: There are no settings to connect Access point.
Connecting...: Currently connected to Access point.
If "Connected" is not displayed after a while, set
the access point connection settings again.
Connected: Complete connection.
• Displayed "Current settings and status" screen
(only when "Connected" or "Connecting..." is displayed)
You can confirm the AP connection status.
(SSlD/Wireless type/Security type/Encryption type/Connection status/Signal strength)
Press "Wireless network" _2_ When you change "Wireless network" -->Press "No"
Follow the directions on screen to complete the setting.
You need to be "Connected" to use network devices.
Please set Access point settings to "Connected".
(example)
@ The Network settings become effective when you close the menu and run "Connection test".
@
Z
©
U_
d)
_q.
G:3
Co
41