Defrosting - AEG Electrolux ER 7533 I Instruction Manual

Positioning the door shelves
To permit storage of food packages of various
sizes, the door shelves can be adjusted in height.
To make these adjustments proceed as follows:
Gradually pull the shelf in the direction of the
arrows until it comes off, then reposition as

Defrosting

Frost is automatically eliminated from the evaporator
of the refrigerator compartment every time the motor
compressor stops, during normal use.
The defrost water drains out through a trough into a
special container at the back of the appliance, over
the motor compressor, where it evaporates.
The freezer compartment, however, will become pro-
gressively covered with frost. This should be
removed with the special plastic scraper provided,
whenever the thickness of the frost exceeds 4 mm.
During this operation it is not necessary to switch off
the power supply or to remove the foodstuffs.
However, when the ice becomes very thick on the in-
ner liner, complete defrosting should be carried out
and it is advisable to carry out this operation when
the appliance is empty.
To carry out complete defrosting of the freezer com-
partment proceed as follows:
Remove any stored food, wrap it in several layers of
newspaper and put it in a cool place.
Pull out the plug from the wall socket or turn the
thermostat knob to the a«O» setting.
Leave the door open.
Introduce the plastic scraper in the appropriate seat-
ing at the bottom centre, as shown in Fig. 15, place
underneath a basin to collect the defrost water.
When defrosting is completed, dry the interior
thoroughly;
keep the scraper for future use;
replace the plug in the socket and, after letting the
appliance run for at least half an hour, replace the
previously removed food into the compartment.
Important
A temperature rise of the frozen food packs, during
defrosting, may shorten their safe storage life. Never
use sharp metal tools to scrape off frost from the
evaporator as you could damage it.
Do not use a mechanical device or any artificial
means to speed up the thawing process other than
those recommended by the manufacturer.
D037
D068
Fig. 12
Fig. 13
Fig. 14
Fig. 15
47