Abit BH6 User Manual page 67

General Discussion about HDD Installation
Installing three HDDs:
on the connector.
Method 1: Set the hard disk drive used for boot up at Master, set the
Method 2: Set the hard disk drive used for boot up at Master, and
Installing three HDDs + one CD-ROM drive:
connection cable must be lined up with pin 1 on the connector.
Set the hard disk drive used for boot up at Master, set another HDD
(the second) at Slave, connect one connector of the 40-pin cable to the
first drive, another connector to the second drive, and the other end of
the cable to connector IDE1 on the motherboard.
Set the third hard disk drive at Master, set the CD-ROM drive at
Slave, connect one connector of the 40-pin cable to the third HDD,
another connector to the CD-ROM drive, and the other end of the
cable to connector IDE2 on the motherboard.
The red line on the connection cable must be lined up with pin 1
second drive at Slave. Connect one connector of the 40-pin
cable to the first drive, another connector to the second
drive, and the other end of the cable to connector IDE1 on
the motherboard.
Set the other (the third) drive at Master, and connect one
end of the 40-pin cable to the drive, and the other end to
connector IDE2 on the motherboard.
connect one end of the 40-pin cable to the drive and the
other end to connector IDE1 on the motherboard. Set
another drive (the second drive) at Master and the third
drive at Slave, connect one connector of the 40-pin cable
to the second drive, another connector to the third drive,
and the other end of the cable to connector IDE2 on the
motherboard.
B-5
The red line on the