Laser Warning Labels - American DJ ROYAL 3D II User Instructions

Royal 3D II
LASER RADIATION
IS EMITTED FROM
THIS APERTURE
AVOID EXPOSURE
A.D.J Supply Europe B.V
Junostraat 2,6468 EW Kerkrade,
Netherlands
Manufactured:
Before use, you need to check
if it is allowed to use this item
in your country!
Specification stickers
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 7

Laser Warning Labels

Specification stickers
A.D.J Supply Europe B.V
Junostraat 2,6468 EW Kerkrade,
Netherlands
Manufactured:
27mm
LASER RADIATION
IS EMITTED FROM
THIS APERTURE
AVOID EXPOSURE
40mm
40mm
Before use, you need to check
if it is allowed to use this item
in your country!
Royal 3D II
Power Supply:
The ADJ Royal 3D II contains a automatic voltage
switch, which will auto sense the voltage when it is plugged into the
power source. With this switch there is no need to worry about the cor-
rect power voltage, this unit can be plugged in anywhere.
DMX-512:
DMX is short for Digital Multiplex. This is a universal pro-
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers. A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA "IN" and DATA "OUT" XLR terminals located on all DMX
fixtures (most controllers only have a DATA "OUT" terminal).
DMX Linking: DMX is a language allowing all makes and models of
different manufactures to be linked together and operate from a sin-
gle controller, as long as all fixtures and the controller are DMX com-
pliant. To ensure proper DMX data transmission, when using several
DMX fixtures try to use the shortest cable path possible. The order
in which fixtures are connected in a DMX line does not influence the
DMX addressing. For example; a fixture assigned a DMX address of 1
may be placed anywhere in a DMX line, at the beginning, at the end,
or anywhere in the middle. Therefore, the first fixture controlled by the
controller could be the last fixture in the chain. When a fixture is as-
signed a DMX address of 1, the DMX controller knows to send DATA
assigned to address 1 to that unit, no matter where it is located in the
DMX chain.
Data Cable (DMX Cable) Requirements (For DMX and Master/Slave
Operation): The Royal 3D II can be controlled via DMX-512 protocol.
The Royal 3D II is a 5 channel DMX unit. The DMX address is set elec-
tronically using the controls on the rear panel of
the unit. Your unit and your DMX controller require
a approved DMX-512 110 Ohm Data cable for data
input and data output (Figure 1). We recommend
Accu-Cable DMX cables. If you are making your
own cables, be sure to use standard 110-120 Ohm
shielded cable (This cable may be purchased at
almost all professional sound and lighting stores).
Your cables should be made with a male and
female XLR connector on either end of the cable. Also remember that
ADJ Products, LLC - www.adj.com - Royal 3D II Instruction Manual Page 8
Set Up
Figure 1