Adjustments; Iii Adjustments - Cub Cadet GT 2550 Operator's Manual

This section contains information for the various
adjustments on the tractor. Adjustment information for
the mower deck is located in Section V – Mower Deck.
ADJUSTING THE SEAT
WARNING: Do not adjust the seat when
the tractor is moving. Adjusting the seat
while the tractor is moving could cause
the operator to lose control of the tractor.
Both seat arm rests can be rotated upward for mount-
ing and dismounting the tractor, or for the personal
comfort of the operator.
Before starting the tractor, adjust the seat forward or
rearward to the most comfortable driving position. To
reposition the seat, move the seat adjustment lever
(See Figure 11) toward the left and slide the seat
forward or rearward. Release the adjustment lever
when the seat is comfortably positioned. Gently rock
the seat forward or rearward to be sure the seat is
locked in place.
Figure 11
ADJUSTING THE BRAKES
During normal operation of this tractor, the brakes are
subject to wear and will need periodic examination and
adjustment.
To check the brake adjustment, position the tractor on
a firm and level surface. Stop the tractor engine and
remove the ignition key. Pull and lock the transmission
release lever in the "TRANSMISSION RELEASED"
position. Perform the following checks:
1. Engage the brake pedal lock. If the tractor can be
pushed forward or rearward, the braking force
must be increased.
2. Release the brake pedal lock. If the tractor cannot
be pushed forward or rearward, the braking force
must be decreased.
SECTION III. ADJUSTMENTS
Move Lever
to Left
SEAT
ADJUSTMENT
LEVER
To adjust the braking force proceed as follows (Refer
to Figure 12):
1. Place the tractor on a level surface with the brake
pedal lock disengaged. Stop the tractor engine
and remove the ignition key.
2. Working from the under right side of the tractor, at
the brake pedal shaft, locate the front threaded
end of the brake rod:
• Remove the internal cotter pin from the brake
rod adjustment ferrule and withdraw the ferrule
from the brake cam. See Figure 12.
• Loosen the hex flange insert lock nut from
against the ferrule.
To increase the braking force —
Turn the ferrule clockwise (inward) one full turn at
a time until the ferrule can be inserted into the
brake cam while applying a minimal tension on
the spring.
To decrease the braking force —
Turn the ferrule counterclockwise (outward) one
full turn at a time until the ferrule can be inserted
into the brake cam while applying a minimal
tension on the spring.
3. Turn the ferrule counterclockwise (outward) one
full turn to release the slight spring tension.
Tighten the hex flange insert lock nut against the
ferrule, then insert the ferrule into the brake cam
and secure with the internal cotter pin.
Viewed from top (fender off)
INTERNAL
COTTER PIN
BRAKE
Recheck the brake adjustment to ensure proper brake
operation before operating the tractor. If brake rod
adjustment does not correct the problem, see your
authorized Cub Cadet dealer.
20
HEX FLANGE
INSERT LOCK NUT
ADJUSTMENT
FERRULE
BRAKE
ROD
SPRING
CAM
Figure 12