Advertisement
1
Note:
When the optional Stacker is installed,
lift up the tray of the Stacker and then
open cover A.
2
Note:
Place the cartridge on a clean, flat
surface.
3
Paper Jam A B (Cover A or B)
Note:
When jammed paper cannot be
removed easily, turn the roller to take
tension off the paper, then pull it
straight out.
4
5
6
7
Note:
When the optional Duplex Unit is
installed, open the Duplex Unit's
cover before opening cover B.
Warning:
w
Unless specifically instructed in this
guide, be careful not to touch the
fuser, which is marked CAUTION
HIGH TEMPERATURE, or the
surrounding areas. If the printer has
been in use, the fuser and the
surrounding areas may be very hot.
If you must touch one of these areas,
turn off the printer and wait 30
minutes to allow the heat to subside
before doing so.
8
Warning:
w
Be careful not to touch the rollers in
the fuser unit, they may be very hot.
9
10
Note:
When the optional Duplex Unit is
installed, close the Duplex Unit's
cover after closing cover B.
11
Advertisement
