Kawai KDP80 Owner's Manual page 35

3. Place the piano on the front half of the stand so that the metal
fitting holes are seen when viewed from the top. Slide the
piano backward while holding it with one hand so that it does
not incline and fall from the stand. The hooks on the piano are
then engaged with the metal fittings on the Side Panels. Pay
attention so that hands or fingers are not caught between the
stand and piano.
Fasten the piano and the stand with four bolts (with plain
washers and spring washers)(G).
First, loosely tighten the bolts to adjust the unit position in
order to make sure that all four bolts can be inserted straight.
Then, tighten the bolts.
Make sure that the bolts are tightened until the spring washers
collapse.
Caution Ÿ Ensure that the KDP80 digital piano is correctly secured to the stand by using the bolts included.
Failing to do so may result in the unit falling from the stand, causing damage or personal injury.
4. Insert the pedal connection cord that comes from Pedal Board
(C) into the piano's pedal jack and fasten with cord clamps.
5. Turn the Adjuster (installed on the bottom of C) until it touches
the floor to support the pedal board.
Caution
Ÿ The pedal board may break if the adjuster
is not touching the floor correctly. When
moving the KDP80 digital piano, ensure
that the unit is lifted clearly from the floor
and not dragged.
(G)
backside of the unit
Pedal jack
Pedal board
Floor
Adjuster
Page
5
Hand or Finger
catching hazard
Cord
clamp
Pedal
cord
connector
Locking
tab
6