Kawai KDP80 Owner's Manual page 34

Page
4
2) ASSEMBLY INSTRUCTIONS
Caution Ÿ Ensure that this section is read thoroughly before attempting to assemble the KDP80 digital piano, and
Ÿ When moving the KDP80 digital piano, ensure that hands are not caught in the unit, and that the piano
Before attempting to assemble the KDP80 digital piano, ensure that all parts are included.
A Phillips-head screwdriver will also be required to assemble the unit (not included).
¢ PARTS PROVIDED
Side Panel (A) ............................................. 2 pcs.
Back Panel (B) ..............................................1 pc.
Pedal Board (C) ............................................1 pc.
Screw (D) .................................................... 2 pcs.
Screw (E) .................................................... 8 pcs.
Bolt (with plain washers and
spring washers) (G) .................................... 4 pcs.
Adjuster (H) ...................................................1 pc.
¢ ASSEMBLY SEQUENCE
1. Insert the Adjuster (H) approximately 1 cm into the bottom of
the Pedal Board (C).
Untie and extend the connection cord from the Pedal Board.
Loosely fasten the left and right Side Panels (A) to the Pedal
Board (C) using a single short screw (E) for each side. After
ensuring that the correct Side Panels are used for the left and
right side, and that the pedal cable is not caught between the
assembled parts, securely fasten the Side Panels to the Pedal
Board using an additional four short screws (E) on each side.
2. Fasten the Back Panel (B) to the left and right Side Panels (A)
using a single long screw (D) on either side.
Then, fasten the Back Panel to the Pedal Board using four
short screws (E).
6
that two or more people work on unit assembly.
is not dropped on an individual's feet.
Screw (D) Screw (E)
ø4 Î 30 ø4 Î 16
Bolt (G) Adjuster (H)
M6 Î 25
Arrow
(C)
(A)
Pedal support insert hole
Pedal cable
(back of the pedal board)
(E)
(H)
(A)
(C)
(B)
(D)
(E)