Table of Contents
Advertisement
HV- 29LPZ
SPECIFIC SERVICE INSTRUCTIONS
DISASSEMBLY PROCEDURE
REMOVING THE REAR COVER
1. Unplug the power c ord.
2. Remove the 16 screws marked !
3. Withdraw the rear cover toward you.
REMOVING THE AV TERMINAL BOARD
" After removing the rear cover.
1. Remove the 5 screws marked "
2. Withdraw the AV terminal board toward you.
REMOVING THE CHASSIS
" After removing the rear cover.
1. Slightly raise the both sides of the c hassis by hand and remove
the 2 claws under the both s ides of the chas sis from the front
cabinet.
2. Withdraw the chass is backward.
(If necess ary, take off the wire clamp, connectors etc.)
REMOVING THE DOME SPEAKER BOX / SPEAKER
" After removing the rear cover.
1. As s hown in Fig. 1, remove the 2 screws marked #
remove the dome speaker box.
2. Remove the 5 screws marked $
remove the dome box.
3. Remove the 4 screws marked %
remove the HONE RING.
4. Remove the 4 screws marked &
remove the speaker.
5. Follow the same steps when removing the other hand dome
speaker box / speaker.
NOTE : When removing the screws marked #
box, remove the lower side sc rew first, and then remove the
upper one.
REMOVING THE TWEETER SPEAKER
" After removing the rear cover.
1. Remove the 7 screws marked '
remove the HONE PANEL.
2. Then remove the tweeter speaker screws to remove it.
8
! as shown in the Fig. 1.
!
!
" as shown in the Fig. 1.
"
"
# , then
#
#
$
$ as shown in the Fig.2, then
$
% as shown in the Fig.2, then
%
%
& as shown in the Fig.2, then
&
&
# of the dome speaker
#
#
' as shown in the Fig.2, then
'
'
CHECKING THE PW BOARD
To check the back side of the PW Board.
1) Pull out the chassis . (Refer to REMOVING THE CHASSIS).
2) Erect the c hassis vertically so that you c an easily check the
back side of the PW Board.
[CAUTION]
" When erec ting the chassis, be careful s o that there will be no
contacting with other PW Board.
" Before turning on power, make sure that the wire connector is
properly connec ted.
" When conducting a check with power supplied, be sure to c onfirm
that the CRT EARTH WIRE (BRAIDED ASS'Y) is connected to
the CRT SOCKET PW board.
WIRE CLAMPING AND CABLE TYING
1. Be sure to clamp the wire.
2. Never remove the c able tie used for tying the wires together.
Should it be inadvertently removed, be sure to tie the wires with
a new c able tie.
DOME SPEAKER BOX
SPEAKER
HORN
(Tweeter)
G
( × 7)
SPEAKER
HORN
PANEL
No.52012
F
(×4)
(×4)
HORN RING
DOME BOX
Fig. 2
E
D
(×5)
Advertisement
Table of Contents
