Installation Instructions; Important Recommendations; Tools/Materials Required - GE SmartWater GXSV10C Owner's Manual And Installation Instructions

General electric water filtration system owner's manual and installation instructions
Table of Contents

Advertisement

Available languages

Available languages

Installation Instructions.

Important Installation Recommendations
Read entire manual. Failure to follow all guides and rules could cause personal injury or property damage.
I Check with your local public works department for plumbing
codes. You must follow their guides as you install the Water
Filtration system.
I Use the Water Filtration system on a potable, safe-to-drink, home
COLD water supply only. The filter cartridges will not purify water
or make unsafe water safe to drink. DO NOT use on HOT water
(100°F max.).
I Protect the Water Filtration system and piping from freezing.
Water freezing in the system will damage it.
I Your Water Filtration system will withstand up to 125 psi water
pressure. If your house water supply pressure is higher than
100 psi during the day (it may reach higher levels at night),
install a pressure-reducing valve before the system.
Tools and Materials Required for Installation
I Slotted and Phillips screwdrivers
I Pliers and adjustable jaw wrench
I Hand- or battery-powered drill and 1 ⁄ 4 " bit (saddle valve
installation)
I Electric drill and drill bit to drill 1"–1 1 ⁄ 4 " hole (type as
required) if mounting hole is needed for faucet
CAUTION:
To avoid damaging the sink, consult
a qualified plumber or installer for drilling procedures.
Special drill bits may be needed for porcelain or
stainless steel.
Installation Overview
Locate the drinking water
system on the cold water
supply pipe, under the
kitchen and/or bathroom
sink, to filter the cold
drinking water.
Shutoff valve
NOTE: To change the filter
cartridge, you must turn off the
water. A nearby shutoff valve is
convenient. Most sinks already
have shutoff valves on the
supply pipes.
Filtered
water faucet
Sink
Battery pack
Hot
Cold
Water supply valve
WARNING:
Do not use with water that is
microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
GXSL03C (rev. 2) and GXSV10C are certified for cyst
reduction and may be used on disinfected water that
may contain filterable cysts. The water should be tested
periodically to verify that the system is performing
satisfactorily. Small parts remaining after the installation
could be a choke hazard. Discard safely.
Contents included with the product:
I Water filter assembly, including mounting bracket
and screws
I Product Literature (Owner's Manual and Installation,
Product Data Sheet, Owner Product Registration Card)
I Water supply/saddle valve
I Filtered water faucet for sink or countertop mounting
I Electronic indicator faucet base and battery pack
(GXSV10C only)
I 3 ⁄ 8 " tubing and fittings to make all needed connections
I Sump wrench
Tubing insert
Tubing adapter
Compression nut
Tubing
Water in
Tubing
Filter I
Water out
Mounting
screw (2)
Filter II
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gxsl03c

Table of Contents