Advertisement
PROBLEM
PERMANENT PRESS
AND "NO-IRON"
ITEMS
POSSIBLE CAUSE AND REMEDY
. Leaving clothes in dryer after tumbling stops. tiediately after dryer stops
tumbling, remove clbthes and place them on hangers.
. Too few items in dryer. If drying only one article, add two or more simflar articles,
even if dry, to insure proper tumbling.
clothes, with lighter permanent press items such as shirts or blouses. Also do not wash
or dry permanent press items with regular laundry.
loads should always be sder than regular loads.. ,no more than medium Ioads.
Use of incorrect wash and dry cycles, Use permanent press wash cycle which
provides a cool-down rinse to rninimi= wrintiing. Nso, use automatic dry ~cle.
Incorrect water level. Use large level for medium load; medium level for srndl load.
detergent.
. Accumulation of lime scrde due to use of carbonate detergents. If a non-phosphate
detergent must be used, avoid the use of a carbonate-butit detergent.
To remove Wubbom tinMes—
. Rerinse and dry on automatic dry setting.
. If unsuccessful, retumble on high heat for 1O-U mil;utes and hang immediately.
Iron carefully,
. Send td cleaners far pressing.
Some wrirddes may remain which cannot be removed?
If you foIiow good laundry procdures and permanent press cloties stfil come out writi~, the
imparts tie memory, a loss or decrease of permanent press performance will result.
or warm water
press syntietic/cotton blends, the -on portion of
23
with plenty of
Advertisement
