GE Dryer Owner's Manual And Installation Instructions page 23

SET REAR LEGS
6
Remove the level and tilt the washer forward
(pivot on front legs) about 4 to 6 inches and
gently lower the rear legs back onto the floor.
This action will set rear leg adjustments to
correspond to front settings.
LEVEL THE WASHER
7
Move the washer into final position.
• To check if the washer is level side to side,
open the lid and place a level at the back of
the opening above the dispenser drawer.
• To check if the washer is level front to back,
place a level at the side of the washer on
the edge where the cabinet side meets the
top cover.
Lower
If the washer is not level, adjust the front
leveling legs. Turn clockwise to raise,
counterclockwise to lower.
Installation Instructions
Raise
23
ATTACH SERIAL CABLE FOR
8
WASHER/DRYER
COMMUNICATION
(if desired)
Attach the serial cable shipped with the dryer
for washer/dryer communication to the serial
port on the back of the washer.
Serial Port
Rear of Washer