Dmx Traits - American DJ X-Move LED 25R User Instructions

X-Move LED 25R
Channel Value
6
0 - 7
8 - 15
16 - 131
132 - 139
140 - 181
182 - 189
190 - 231
232 - 239
240 - 247
248 - 255
7 0 - 255
8
0 - 7
8 - 28
29 - 49
50 - 70
71 - 91
92 - 112
113 - 133
134 - 154
155 - 175
176 - 196
197 - 217
218 - 238
239 - 255
9 0 - 255
American DJ - www.americandj.com - X-Move LED 25R Instruction Manual Page 17
®

DMX Traits

Function
SHUTTER/STROBE
BLACKOUT
SHUTTER OPEN
STROBING SLOW - FAST
SHUTTER OPEN
SHUTTER SLOW OPEN - FAST CLOSE
SHUTTER OPEN
SHUTTER FAST OPEN - SLOW CLOSE
SHUTTER OPEN
RANDOM STROBE
SHUTTER OPEN
DIMMER 0% - 100%
MOVING HEAD MOVEMENT
NO FUNCTION
MOVEMENT 1
MOVEMENT 2
MOVEMENT 3
MOVEMENT 4
MOVEMENT 5
MOVEMENT 6
MOVEMENT 7
MOVEMENT 8
MOVEMENT 9
MOVEMENT 10
MOVEMENT 11
MOVEMENT 12
MOVEMENT SPEED FAST - SLOW
X-Move LED 25R
This unit comes with interchangable gobos. When changing
the gobos please be very careful. Follow the instructions below,
and see the figure pictures on the next page.
Caution! Never open the unit when in use. Always disconnect
the main power before attempting to change the gobos.
1. To change the gobo, you must remove the top half of the
moving head. The top half of the moving head does not
have the lens attached to it. The lens is on the top half of the
head.
2. Unscrew the 3 phillips screws that secure the top half of the
head. Remove the top half of the head.
3. When you remove the shell you will be able to access the
gobo wheel (see picture below). Rotate the head so that the
lens is aimed up. Turn the gobo wheel with your hand until
you find the gobo you would like to change.
4. Using a pair of needle nose pliers, grab the fixture ring that
holds the gobo in place and remove the ring.
5. Once the ring is removed, rotate the head upside down so
that the gobo falls into your hand.
6. Carefully insert your new gobo and insert the fixture ring.
7. Reassemble the unit.
American DJ - www.americandj.com - X-Move LED 25R Instruction Manual Page 18
®
Gobo Replacement