Setting The Video Signal; Selecting The Area Group; Selecting The Video Format - Pioneer AVH-2450BT Owner's Manual

Section
12 Menu operations
! After you set up the rear view camera set-
ting, move the shift lever to REVERSE (R)
and confirm that the rear view camera
video is shown on the display.
! Change this setting if the display switches
to the rear view camera video by error while
you are driving forward.
! To stop watching the rear view camera
video and return to the source display,
press and hold MUTE.
! Touch the RearView source icon to display
the rear view camera image while driving.
Touch the source icon again to turn the
rear view camera off. For details, refer to Se-
lecting a source using the touch panel keys
on page 12.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Camera Polarity on the system
menu to select the appropriate setting.
! Battery – When the polarity of the con-
nected lead is positive while the shift lever
is in REVERSE (R) position
! Ground – When the polarity of the con-
nected lead is negative while the shift lever
is in REVERSE (R) position
! Off – When a rear view camera is not con-
nected to this unit
Note
You can also switch the rear view image by press-
ing the touch key, regardless of the
Camera Polarity setting on the sytem menu.
Refer to Basic operations on page 11.

Selecting the video format

You can switch the video output format of V
OUT between NTSC and PAL.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Video Output Format on the sys-
tem menu to select the video output for-
mat.
NTSC—PAL
66
En
Note
You can switch the video output format only for
the source from this unit.

Setting the video signal

When you connect this unit to an AV equip-
ment to this unit, select the suitable video sig-
nal setting.
! As this function is initially set to Auto, the
unit will automatically adjust the video sig-
nal setting.
! You can operate this function only for the
video signal input into the AV input.
1 Display the system menu.
Refer to Introduction of menu operations on
page 45.
2 Touch Video Signal Setting on the func-
tion menu.
Video Signal Setting items are displayed.
! AV – Adjusts the AV video signal
! AUX – Adjusts the AUX video signal
! Camera – Adjusts the rear view camera
video signal
3 Touch c or d to select the desired
video signal appears.
Auto—PAL—NTSC—PAL-M—PAL-N—
SECAM

Selecting the area group

1 Select the TV source.
Refer to Basic operations on page 11.
2 Display the system menu.
Refer to Introduction of menu operations on
page 45.
3 Touch TV Country Group on the func-
tion menu.
4 Touch c or d until the desired area
group appears.
Country1 (CCIR channel)—Country2 (IN
channel)—Country3 (CHN channel)—
Country4 (U.K. channel)—Country5 (OIRT
channel)—Country6 (AUSTRALIA channel)—
Country7 (SAF channel)