Advertisement
PROBLEM
WASHER IS NOISY
WASHER PAUSES
IN
CYCLE
If you need more help... call, toll free: GE Answer Center
USER MAINTENANCE INSTRUCTIONS
The ~b. The pdcelain is self-cleaning. Leave lid
open after washing to allow moisture to evaporate.
Do not use harsh or gritty cleansers.
The Exterior. Wipe off any spills of washing
compounds. Wipe or dust with damp cloth. Try
not to hit surface with sharp objects.
How to remove the agitator
To remove the agitator,
snap the cap off and remove ~ —
the screw. Then remove
the agitator extender (on
models so equipped)
and the agitator.
To
replace
the
agitator,
down onto the shaft so
that it fits snugly into
place. Replace the agitator
extender (on models so
equipped), the screw
and the cap.
26
(continued)
POSSIBLE CAUSE
Make sure washer is level and firm to the floor with rubber foot
pads in place and front jam nuts tight. See your Installation Instructions.
A sharp, distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission locks in. This sound is norrnd.
Heavily unbalanced loads can cause the washer to vibrate excessively during
spin, and may cause it to move from its original position. In extreme cases
(usually occurs when washing a single, heavy item or a small load in a tub full
of water), the spin basket may strike the outer tub, creating a loud but h@ess
noise. To correct, open the lid and redistribute the load evenly about the wash
basket. Close the lid and restart.
Washer norrndly pauses between washing
spin or between spin and rinse.
CARE Am CLEAN~G
Cap
Screw
Extender
(on some models)
—
Agitator
,
—
(Appearance
may
steps.. such as between wash and
@
/ 800.626.2000/ consumer information service
To Store Washer. Ask service technician to remove
water from drain pump and hoses to prevent freezing.
Do not store the washer where it will be exposed
to the weather.
For Long Vacations. Be sure water supply is shut off
at faucets and drain all water from hoses if weather
will be below freezing.
To remove limestone from Filter-Flo pan
Soak filter pan in a preheated 160°F. (71°C.)
solution of half vinegar and half water for 15
minutes. Then brush each side of pan with a stiff
bristle brush while flushing with running water.
CAUTIONS:
can damage porcelain.
Do not exceed 180°F. (82°C.) or filter pan
may warp.
Advertisement
