GE WWA8354V Use And Care Manual page 27

PROBLEM
POSSIBLE CAUSEAND REMEDY
SNAGS,HOLES, As
Permanent"Press garments age they may show fraying at
TEARS, RIPS collars and cuffs. This is normal due to weakening of fibers by '
OR EXCESSIVE the Permanent Press process. It is not caused by washer. Youcan
WEAR slow this process by washing small Permanent Press loads with a
(continued) Large Water Level. Do not wash heavy items such as towels with
Permanent Press. Remove collar stays, when possible.
Roughness or burrs on agitator may cause rips or tears. Check
agitator and file rough spots if necessary.
May be caused by use of Normal Wash/Spin speed for delicate
articles. Use Gentle Wmh/Spin speed. Refer to Garment
Manufacturers' Care Labels.
Garments weakened by age, sun or atmosphere. This is inevitable
and is not caused by washer. Slow process by washing on Gentle
Wash/Spin speed.
Too large loads, or too little water. Load washer only with
number of items that will move freely. Select correct water level.
HEAVILY SOILED AREAS Use SP07SCRUBZ3E. Cycle. Seepage 10.Or pretreat with liquid
such as collars and cuffs detergent and wash in ReguIar Cycle.
@@@@
WASHER
QMake sure cord is plugged into outlet.
WON'T OPERATE
. M&e sure both hot and cold ~ucets ~ ~rned on.
Make sure controls are set and cycle selector knob is pulled
out to
an ON
position.
M&e sure lid is closed. Washer will not fill, spin or agitate with
lid open.
Check house fines or circuit breakers. If another appliance is
sharing the electrical outlet, remove it. Washer should have
separate outlet.
WATERTEMPERATURE
Make sure temperature selector controls are properly set.
IS INCORRECI'
Make sure hot ~d cold tiuce~ are turned on and regulated
correctly.
. Make sure hoses me connected to correct
faucets...hot to hot, cold to cold.
Water valve screens maybe stopped up.
o *
Remove inlet hoses from water valve.
$/
Clean the screens and reinstall hoses.
Check household water heater to m&e sure it is delivering water
at 140°to 150°F.
(continued next page)
2'7