Wiring; Wiring For The Optional Fan Kit - Montigo L42DF-ST Installation, Operation & Maintenance Manual

L42DF-ST See-thru Indoor Gas Fireplace
Mantels & Surrounds
NOTE: National Canadian Gas Association mantel test requirements
are for fire hazard prevention to combustible materials.
New technology, to meet consumer and government demands for the
wise use of energy, has prompted us to manufacture many models of
fireplaces which are hot, fuel and energy efficient.
Please be aware; temperatures over the mantel will rise above normal
room temperature and walls above fireplace may be hot to touch.
Drywall/ Sheetrock
Non-combustible Header
(Supplied by Montigo)
Non-Combustible
Facing Material
Figure 25. Combustible surrounds, (Both Sides Typical).
Page 12
Installation
L42DF-ST
6" 6"

Wiring

Gas Control and Pilot Wiring
Honeywell (Q3450)
Pilot Assembly
Gas Control
Connector
Fan Plug
Receptacle
Gnd Screw
Wall Switch
Figure 26.
Wiring for the L42DF-ST-I with Honeywell gas control and pilot.

Wiring for the optional Fan Kit

All L42DF-ST Indoor fireplaces may be equipped with optional fan kits
for circulating heat into the living space.
Installations in Canada which employ the fans must be electrically
grounded in accordance with CSA C22.1 Canadian Electrical Code
Part 1 and/or Local Codes.
Installations in the USA which employ the fans must be grounded in
accordance with local codes or, in the absence of local codes, with the
National Electrical Code, ANSI/NFPA 70-1987.
For more information see the Fan Kit Installation Guide included with
the fan kit.
NOTE: If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
5/1/60 Supply
G L1 L2
Quick Connect
Figure 27a. Wiring schematic for optional fans.
f i r e f e a t u r e
L42DF-ST-I
Pilot Electrical
Harness Connector
Honeywell Gas
Control (SV9501M)
Junction Box
115VAC
24VAC
40 VA
Transformer
L42DF-ST
L2-WH
G
L1-BLK
p g lu to motor
Part No. XG0812 - 081009
Black
White
Green