Engine Oil And Oil Strainer - Yamaha CYGNUS.X NXC125 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
1
3
ZAUM00**
4
1. Spark plug gap
Spark plug gap:
5
0.6~0.7 mm (0.024~0.028 in)
6
2. Clean the surface of the spark plug
gasket and its mating surface, and
then wipe off any grime from the
7
spark plug threads.
3. Install the spark plug with the spark
8
plug wrench, and then tighten it to
the specified torque.
9
Tightening torque:
Spark plug:
13 Nm (1.3m • kgf, 9.4ft • lbf)
NOTE:
If a torque wrench is not available when
installing a spark plug, a good estimate
of the correct torque is 1/4~1/2 turn past
finger tight. However, the spark plug
should be tightened to the specified
torque as soon as possible.
4. Install the spark plug cap.
5. Install the panel.
6-8

Engine oil and oil strainer

The engine oil level should be checked
before each ride. In addition, the oil must
be changed and the oil strainer cleaned
at the intervals specified in the periodic
maintenance and lubrication chart. The
engine oil must also be changed at the
initial 1000 km (600 mi) and when the
oil change indicator changes from green
to red. The oil change indicator must be
reset after the initial 1000 km (600 mi).
(See page 3-2 for reset procedures.)
To check the engine oil level
1.Place the vehicle on the centerstand.
NOTE:
Make sure that the vehicle is positioned
straight up when checking the oil level.
A slight tilt to the side can result in a
false reading.
2. Start the engine, warm it up for sev-
eral minutes, and then turn it off.
3. Wait a few minutes until the oil
settles, remove the oil filler cap,
wipe the dipstick clean, insert it
back into the oil filler hole (without
EAUT1350